COMTEC 6000

Information

The COMTEC^® 6000 is an InSitu analyzer for measurement of O₂ and CO_e (sum of unburned molecules - CO, H2, C_xH_y) in flue and process gases. The correlation of the O₂ and CO_e measurements enables combustion fine tuning in real time.

Both sensors are located within the process at the tip of the probe installed directly in the flue gas duct. This allows for fast and continuous flue gas measurement, enabling fast response rates to changes in the flue gas composition.

The analyzer was designed with low maintenance in mind, with minimal calibration requirements and user-friendliness. Furthermore high costs for investment and maintenance, especially when comparing to extractive analyzers, can be avoided.

Technical Data

Insertion depth of probe

up to 1820 mm

O₂ / CO_e ranges

0 - 25 % O₂
min.: 0-1000 ppm /
max.: 0-5000 ppm CO_e
(others on request)

Sensor accuracy O₂

< 0.5 % of measured value or
0.02 Vol % O₂
(higher value valid)

Sensor accuracy CO_e

better 5 % of range end

Reaction time

< 1 sec. (on test gas)

Process gas temperature

max. 500 °C
max. 1400 °C (with cooling protection tube)

Ambient temperature

-40 °C to 80 °C (probe)
-20 °C to 55 °C (electronic unit)

Interface

MODBUS RTU via RS232/RS485, HART, FIELDBUS, ENOTEC REMOTE

IP code

IP65 (probe)
IP66 (electronic unit)